100% Guaranteed Results JN0-363 Unlimited 265 Questions [2023]
JN0-363 Dumps PDF - Want To Pass JN0-363 Fast
NEW QUESTION # 119
Click the Exhibit button. What does IS-IS/18 mean in the output displayed in the exhibit?
- A. These routes are internal Level 2 routes.
- B. These routes are external Level 1 routes.
- C. These routes are internal Level 1 routes.
- D. These routes are external Level 2 routes.
Answer: A
NEW QUESTION # 120
Which three statements are true about the BGP community attribute? (Choose three.)
- A. Communities are used in the route selection process.
- B. Communities can be used to signal local preference in other AS networks.
- C. There are three well-known communities.
- D. Routing policies can be simplified using BGP communities.
- E. Only well-known communities can be passed between AS networks.
Answer: B,C,D
NEW QUESTION # 121
Which two statements are correct about the BGP MED attribute? (Choose two.)
- A. BGP uses the MED value when peering to two or more connections to the same upstream AS
- B. BGP uses the MED value when peering to two different upstream ASs
- C. BGP assumes the MED value to be 0, if not already defined
- D. BGP routes require the MED attribute be defined
Answer: A,C
Explanation:
https://www.juniper.net/documentation/en_US/junos/topics/topic-map/med-attribute.html
NEW QUESTION # 122
Which two statements are true about IBGP on MX Series devices? (Choose two.)
- A. Interface Lo0 must be used for peering
- B. It is loop free by default
- C. It does not support multihop
- D. Neighbors can be located anywhere within the AS
Answer: B,D
Explanation:
https://www.juniper.net/documentation/en_US/junos/topics/topic-map/bgp-ibgp-peering.html
NEW QUESTION # 123
Exhibit
Referring to the exhibit, which statement is true about VRRP?
- A. Both routers are in the same state because they have the same VRRP priority.
- B. The routers should use different virtual IP addresses for VRRP to function correctly.
- C. VRRP communication between the two devices is not functioning correctly.
- D. RRP Is functioning normally in active/active mode.
Answer: B
NEW QUESTION # 124
An Ethernet bridge is configured such that all interfaces are in a single broadcast domain.Which two tasks does the bridge perform in response to receiving a frame with an unknown unicast destination MAC address? (Choose two.)
- A. It drops the frame.
- B. It floods the frame out of all interfaces except the one on which is was received.
- C. It learns the source MAC address.
- D. It learns the destination MAC address.
Answer: B,C
NEW QUESTION # 125
Click the Exhibit button. Based on the configuration shown in the exhibit, what will be the state of the IS-IS levels on interface ge-0/0/0.100?
- A. Level 1 is enabled and Level 2 is disabled.
- B. Level 1 is enabled and Level 2 is enabled.
- C. Level 1 is disabled and Level 2 is disabled.
- D. Level 1 is disabled and Level 2 is enabled.
Answer: C
NEW QUESTION # 126
Click the Exhibit button.
You have configured IPv6 over IPv4 tunneling, as shown in the exhibit. However, hosts connected to network 2001:0:0:1::0/64 cannot communicate with hosts on network 2001:0:0:2::0/64. The router R2 has a similar configuration as the R1 router.
How would you solve this problem?
- A. Configure an IPv6 address on the tunnel interfaces
- B. Configure an IGP across the tunnel interfaces
- C. Configure the next hop of the inet6.0 static route to point to the physical interface between the routers
- D. Configure the next hop of the inet6.0 static route to point to the IPv4 address of the remote router
Answer: D
NEW QUESTION # 127
Which two functions are performed by the OSPF designated router? (Choose two.)
- A. It forms adjacencies with all the other OSPF routers on the link
- B. It designates some routers as inactive when not needed
- C. It advertises link-state information to the AS
- D. It chooses the backup designated router
Answer: A,C
Explanation:
https://sites.google.com/site/amitsciscozone/home/juniper-junos/junos--ospf-designated-router
NEW QUESTION # 128
What is the TTL value for EBGP?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION # 129
Your customer would like to forward traffic using DLCI 600 and maintain Layer 2 information across a VPN.Which solution will meet these requirements?
- A. an IPsec VPN
- B. Virtual Private LAN Service (VPLS)
- C. a Layer 3 VPN
- D. a Layer 2 VPN
Answer: D
NEW QUESTION # 130
Click the Exhibit button.
Your co-worker configures the ge-0/0/0 interface with an IPv6 address of 2001:db8:0:9::/64. After committing the configuration, your co-worker executes the command shown in the exhibit.
What is the fe80::206:aff:fe0e:e01/64 address in this scenario?
- A. the multicast address
- B. the link-local address
- C. the statically assigned address
- D. the loopback address
Answer: B
NEW QUESTION # 131
You are logged into a PE router participating in a Layer 3 VPN as defined in RFC 4364. You would like to ping the remotely connected CE router's loopback address. The address of the loopback is 122.161.2.1, the VPN routing-instance is called VPN-C.Which command will accomplish this goal?
- A. ping routing-instance VPN-C 122.161.2.1
- B. ping VPN-C 122.161.2.1
- C. ping vpn-instance VPN-C 122.161.2.1
- D. ping instance VPN-C 122.161.2.1
Answer: A
NEW QUESTION # 132
Which two fields of a hello packet must match on both routers when forming an OSPF adjacency? (Choose two.)
- A. Router priority
- B. Designated route
- C. Network mask
- D. Hello interval
Answer: C,D
NEW QUESTION # 133
Click the Exhibit button.
Which type of route is shown in the exhibit?
- A. aggregate
- B. generate
- C. kernel
- D. static
Answer: B
NEW QUESTION # 134
Referring to the exhibit, internal BGP between R1 and R2 is not establishing.
What is the problem In this scenario?
- A. R1 and R2 must each have unique AS numbers.
- B. R1 needs to be configured with an explicit router ID.
- C. R1 does not have a route to 192.168.200.2.
- D. R1 needs to be configured with a next-hop self policy.
Answer: C
NEW QUESTION # 135
Click the Exhibit button.
Referring to the exhibit, which two statements are true? (Choose two.)
- A. The OSPF neighbor will be declared down if three BFD hello packets are missed
- B. The OSPF neighbor will be declared down if BFD hello packets are not received for 5 seconds
- C. The OSPF neighbor will be declared down if BFD hello packets are not received for 1.5 seconds
- D. The OSPF neighbor will be declared down if 500 BFD hello packets are missed
Answer: A,C
NEW QUESTION # 136
Exhibit
Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)
- A. R3 is considered a PE router.
- B. R3 is considered an ingress router.
- C. R3 is considered a P router.
- D. R3 is considered a transit router.
Answer: A,C
NEW QUESTION # 137
Click the Exhibit button.
Referring to the exhibit, why is the route hidden?
- A. The wrong BGP address family is enabled for the BGP session
- B. The MPLS LSP to the 192.168.0.2 peer is down
- C. The protocol next hop is not reachable
- D. The route has yet to be verified
Answer: C
NEW QUESTION # 138
Which statement about a virtual-router type of routing instance is correct?
- A. It is used to separate large networks into smaller administrative entities
- B. It is the only routing instance type supported on Junos devices
- C. It is used in Layer 3 VPN implementations
- D. It is used to create and maintain separate routing and forwarding tables
Answer: D
NEW QUESTION # 139
Which MPLS feature works with Constrained Shortest Path First (CSPF) to protect against the primary and secondary paths using the same link?
- A. policy control over LSP selection
- B. LSP metrics
- C. explicit null configuration
- D. fate-sharing
Answer: D
NEW QUESTION # 140
Click the Exhibit.
Referring to the exhibit, which two statements are true? (Choose two.)
- A. The LSP is protected with link protection.
- B. The last node in the path will not pop the MPLS label.
- C. The last node in the path will pop the MPLS label.
- D. The LSP is protected with fast reroute.
Answer: A,C
NEW QUESTION # 141
Click the Exhibit button. Given the OSPF topology shown in the exhibit, how many unique link-state databases are present in the network?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 142
Click the Exhibit.
The router with the configuration shown in the exhibit has two interfaces, both of which are operational and can pass traffic. These interfaces are connected to two different routers, both of which are configured for OSPF area 0.0.0.1. The router has received LSAs and can now send traffic into the backbone area.
Which two statements are correct? (Choose two.)
- A. The router has only a single OSPF adjacency.
- B. The router is an ABR.
- C. The router is an ASBR.
- D. The router has two OSPF adjacencies.
Answer: A,B
NEW QUESTION # 143
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. The ge-0/0'1.0 Interface is configured as passive.
- B. The R2 device is an ABR.
- C. Junos OS default OSPF hello timers and dead intervals are used on all interfaces.
- D. The OSPF Interfaces are configured as point-to-point.
Answer: A,C
NEW QUESTION # 144
......
Updated Verified JN0-363 Q&As - Pass Guarantee: https://www.exam4labs.com/JN0-363-practice-torrent.html
JN0-363 Practice Exam Dumps - 99% Marks In Juniper Exam: https://drive.google.com/open?id=1vjD3yRCGlkq7h0c-ESpoQgn8h23-VhK-