[Jul-2021] Cisco and NetApp FlexPod NS0-176 Exam Practice Dumps
2021 NS0-176 Premium Files Test pdf - Free Dumps Collection
NEW QUESTION 77
How are jumbo frames enabled on the Nexus 5548?
- A. system qosmtu 9216
- B. system mtu jumbo 9000
- C. system jumbo-frame
- D. policy-map type network-qos JUMBOclass type network-qos class-defaultmtu 9216system qosservice-policy type network-qos JUMBO
- E. policy-map type queueingclass type queueing class-defaultmtu 9216
Answer: D
NEW QUESTION 78
Exhibit:
Which hardware component is shown in the exhibit?
- A. FI
- B. FEX
- C. VIC
- D. IOM
Answer: C
NEW QUESTION 79
When configuring a volume to contain a LUN, which administrative tool automatically applies NetApp recommendations?
- A. Microsoft SystemCenter
- B. Data ONTAP command-line interface
- C. VMware vSphere
- D. OnCommand System Manager
Answer: D
NEW QUESTION 80
How many VEMs can one server have?
- A. 0
- B. unlimited
- C. 1
- D. 2
Answer: C
NEW QUESTION 81
Which set of commands maps VLAN 100 to VSAN 100?
- A. Nexus 5000-B# configure terminal Nexus 5000-B(config-vsan) # vlan 100 Nexus 5000-B (config-vsan)# vsan 100 name vsan100
- B. Nexus 5000-A#configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-A (config)# vsan 100 Nexus 5000-A (config-vsan) # fcoe vsan 100
- C. Nexus 5000-A#configure terminal Nexus 5000-A (config) # vlan 100 Nexus 5000- A (config-vlan_ #fcoe vsan 100
- D. Nexus 5000-B# configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-B (config-vsan)# vsan 100 Nexus 5000-B(config- vsan) #vsan 100 name FCoE-VLAN 100
Answer: C
NEW QUESTION 82
Which endpoint's firmware can be directly upgraded (without the use of a Service Profile) using UCS Manager?
- A. CIMC
- B. RAID Controller
- C. HBA
- D. BIOS
Answer: A,D
NEW QUESTION 83
You are attempting to establish a cluster peer relationship between two NetApp clusters, but the peering process fails.
What is a cause for this failure?
- A. The cluster LIFs on each node cannot communicate with the cluster LIFs on each node in the peer cluster.
- B. The intercluster LIF on each node cannot communicate with the intercluster LIF on each node in the peer cluster.
- C. The cluster management LIF for the cluster cannot communicate with the cluster management LIF for the peer cluster.
- D. The node management LIF on each node cannot communicate with the node management LIF on each node in the peer cluster.
Answer: B
NEW QUESTION 84
Which two are two possible features of the 'Call Home' feature in UCS Manager?
- A. Ability to proactively open a case with the Cisco TAC with the 'Smart Call Home' feature
- B. Generates a syslog event
- C. Generates a text message to configured cell phone numbers
- D. Allows UCS to proactively pull down new software updates from Cisco
- E. Generates emails to predefined email addresses when a problem is detected
Answer: A,E
NEW QUESTION 85
When configuring a FlexPod environment for iSCSI boot with Cisco UCS, which item should be preconfigured?
- A. WWPN Pools.
- B. All zoning should be configured.
- C. Zonesets should be created.
- D. IQN and IP address of target.
Answer: D
NEW QUESTION 86
While working on a performance related issue on your FlexPod solution, you notice an unequal distribution of traffic over the physical interfaces of a four port vPC between two Nexus 5000 switches. You would prefer a more even traffic distribution.
Which command would you use to accomplish this task?
- A. ~lacp rate fast~
- B. ~port-channel load-balance ethernet~
- C. ~hardware multicast hw-hash~
- D. ~lacp system-priority~
Answer: B
NEW QUESTION 87
NetApp recommends that your SSL key length be?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 88
Which sends support summary information to NetApp through HTTPS?
- A. TechSupport
- B. AutoSupport
- C. FlexSupport
- D. SnapSupport
Answer: B
NEW QUESTION 89
Which of the following tools is designed to inventory existing VMware vSphere, Linux, and Microsoft Windows Server versions in a customer environment?
- A. Cisco UCS Central
- B. Microsoft Assessment and Planning (MAP) Toolkit
- C. Cisco UCS Sizer for Enterprise Applications
- D. Cisco Resource Comparison Tool
Answer: B
NEW QUESTION 90
Which two technologies must be deployed for a Cisco Nexus 9000 ACI design? (Choose two.)
- A. LACP
- B. spine switch
- C. VSM
- D. APIC
Answer: B,D
NEW QUESTION 91
Which two are required for single-wire management for Cisco UCS C-Series? (Choose two)
- A. 10 GB LOM
- B. FI 6200 family only
- C. VIC 1240
- D. Redundant Nexus 2232PP FEX
- E. VIC 1225
- F. UCS Manager 2.1 or higher
Answer: E,F
NEW QUESTION 92
You are asked to verify your MPIO settings for your ONTAP FlexPod solution. You are using VMware ESXi 6 and FCP as the storage protocol.
In this scenario, which MPIO setting would you use on the ESXi host?
- A. fixed path
- B. fixed path with array preference
- C. round robin
- D. most recently used
Answer: C
NEW QUESTION 93
Which feature allows Cisco Nexus 7000 Series switches to be virtualized at the device level?
- A. VDC
- B. VLAN
- C. VRF
- D. PONG
Answer: A
NEW QUESTION 94
......
Get ready to pass the NS0-176 Exam right now using our Cisco and NetApp FlexPod Exam Package: https://www.exam4labs.com/NS0-176-practice-torrent.html